[U-Boot-Users] Debugging U-Boot with BDI2000

[Wolfgang Denk]

In message <3F604A6E.7030308 at gmx.de> you wrote:
> 
> 1) Is it possible to debug U-Boot with BDI2000 (Linux host) at all?
> (eg. step through the instructions)

Yes, of course!!!

> 2) Do somebody have a working configuration file for BDI2000 (Linux 
> host) to be used with a PXA250-target?

Configuration files for some targets are included  with  the  BDI2000
firmware  -  see  the floppy disk, or the .zip file you received with
the device.

But a configuration file for _some_ PXA250 board is only an  EXAMPLE,
you  cannot use it unchanged on different hardware. You must create a
NEW  configuration  file  which  matches  exactly  the  hardware   as
implemented on your board.

This is not a trivial task, but the knowledge you need to do this  is
necessary to successfully port and debug U-Boot anyway. 

Best regards,

Wolfgang Denk

-- 
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd at denx.de
If programming was easy, they wouldn't need something as  complicated
as a human being to do it, now would they?
                       - L. Wall & R. L. Schwartz, _Programming Perl_