[U-Boot-Users] [PATCH] U-boot-1.1.6 for Wind River SBC8349
Kumar Gala
galak at kernel.crashing.org
Fri Nov 17 23:06:47 CET 2006
On Nov 17, 2006, at 3:34 PM, Paul Gortmaker wrote:
> Hi folks,
>
> I've attached my patches below that add support for the Wind River
> SBC8347E/9E boards. Most of my testing has been done on the SBC8349E
> variant, but earlier versions were also tested on the SBC8347E.
>
> Patches are against the recently released 1.1.6 version of U-Boot.
>
> Thanks to the implementation for the MPC8349 by the folks at
> Freescale,
> a lot of the heavy lifting was already done. Of course there were
> still
> the usual handfull of "gotcha"s. PCI is also supported, and I've
> tested
> with an intel e1000 card. I've left PCI off by default though, since
> there were early rev CPUs that had PCI issues.
>
> Outside of the typical core board files, the only thing I had to
> update
> was the TSEC driver to add support for a new PHY type (Broadcom).
>
> I think I've got all the extra details to make it ready for inclusion
> (e.g. updated MAKEALL, provided a README, etc.) but if there is
> something I need to change/add/update, just let me know and I'll take
> care of it next week.
Glancing at your patch it doesn't look like you are enabling the flat
device tree support. I'd recommend fixing that since its a
requirement for boot future linux kernel's.
- kumar
More information about the U-Boot
mailing list