[U-Boot] [PATCH 2/4 v4] arm: add support for the suen3 board from keymile

[Prafulla Wadaskar]

> -----Original Message-----
> From: Heiko Schocher [mailto:hs at denx.de] 
> Sent: Friday, February 12, 2010 1:36 PM
> To: U-Boot user list
> Cc: Wolfgang Denk; Prafulla Wadaskar; Scott Wood; Stefan Roese
> Subject: [PATCH 2/4 v4] arm: add support for the suen3 board 
> from keymile
> 
> This patch adds support for the Keymile suen3 board which
> is based on the Marvell Kirkwood (88F6281) SoC. As this
> is a variant of the mgcoge2_arm_p1a board, this board
> also uses common code stored in board/keymile/km_arm/km_arm.c
> 
> Signed-off-by: Heiko Schocher <hs at denx.de>
> ---
> - changes since v1:
>   added comments from Wolfgang Denk:
>   get rid of flash_info_t define in board config
>   (to get this working patch 1/2 is introduced/needed)
> 
> - changes since v2:
>   added comments from Wolfgang Denk
>   - rearranged if/else in do_spi_toggle()
>   - added I/O accessor functions for bootcounter
> 
> - changes since v3:
>   added comment Scott Wood
>   - removed nand_init in do_spi_toggle()
> 
>   added comments from Prafulla Wadagaskar
>   - km-arm.h renamed to km_arm.h
>   - reworked eeprom_write_enable() (deleted it)
>     (when reviewing this function, it cropped up, that
>      this pin is connected through a gpio pin, not as
>      in previous version, through the boco (a FPGA))
>   - moved set_sda(), set_scl(), get_sda(), get_scl()
>     to km_arm.c
>   - split patch in 4 patches (for each board an extra patch)
>   - renamed sdramregs.txt in kwbimage.cfg, also license
>     info added.
> 
>  MAINTAINERS             |    1 +
>  MAKEALL                 |    1 +
>  Makefile                |    3 +
>  include/configs/suen3.h |  103

There is some code in earlier patch (i.e 1/4) for this board support that should reflect here.
This gives better understanding

Regards..
Prafulla . .