[U-Boot] Problems flashing kernel

[Kristoffer Ericson]

On Tue, Jun 08, 2010 at 03:05:44PM +0200, Stefano Babic wrote:
> Kristoffer Ericson wrote:
> > Greetings,
> > 
> 
> Hi,
> 
> > When I do:
> > HP Jornada# cp.b 0xC00080000 0x00080000 1296996 (<- my kernel size)
> > Copy to flash... . (and just sits there)
> 
> u-boot uses hexadecimal as default and you do not need to use the 0x
> notation. however, 1296996 is interpreted as hexadecimal (more as 18MB).
> Try with 13CA64, if your size was intended as decimal as I think.

You are quite correct in that, thx. that also explains why it
took a good while longer than usual.

I cannot seem to shake the "Flash not Erased" problem though. Was thinking
to increase timeout of erase/write but they dont change even when I change
the CONFIG_SYS_FLASH_WRITE_TOUT. Any thoughts on that?

> 
> Best regards,
> Stefano Babic
> 
> -- 
> =====================================================================
> DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
> HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
> Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
> =====================================================================