[U-Boot] [PATCH] README.arm-relocation: get relocated address in gdb

[Wolfgang Denk]

Dear Ben Gardiner,

In message <1303996341-6582-1-git-send-email-bengardiner at nanometrics.ca> you wrote:
> When your emulator is connected at reset (or is used to load u-boot)
> it is possible to get the relocation address from the parameter
> passed to relocate_code() instead of building with -DDEBUG and
> extracting from the console messages.

Hm... Maybe we should try and unify code a bit better.

On PowerPC, relocaddr (the start address of the U-Boot image in RAM)
is part of the global data structure, and simply gets printed with the
"bdinfo" command:

	=> bdinfo
	memstart    = 0x00000000
	memsize     = 0x20000000
	flashstart  = 0xFC000000
	flashsize   = 0x04000000
	flashoffset = 0x00000000
	sramstart   = 0x00000000
	sramsize    = 0x00000000
	bootflags   = 0xFFFE72CC
	intfreq     = 1066.667 MHz
	busfreq     = 266.667 MHz
	ethaddr     = 00:10:ec:01:08:84
	eth1addr    = 00:10:ec:81:08:84
	IP addr     = 192.168.100.6
	baudrate    = 115200 bps
===>	relocaddr   = 0x1FF50000

Why not simply follow this example?

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
If the hours are long enough and the pay  is  short  enough,  someone
will say it's women's work.