[U-Boot] [PATCH 2/2 v2] mpc5200, digsy_mtc: add support for rev5 board version

[Wolfgang Denk]

Dear Heiko Schocher,

In message <1294903500-2018-1-git-send-email-hs at denx.de> you wrote:
> difference to previous board version:
> - M29W128GH flash from Numonyx
> - SDRAM ISSI IS45S16800 (Option A2 105°C)
> - rev5 uses RTC RV-3029-C2
> - update cs0 and cs1 baseaddr and length
>   depending on the detected flash size.
> - added Werner Pfister <Pfister_Werner at intercontrol.de>
>   as maintainer for the digsy board variants
> - As the M29W128GH needs a special flash_cmd_reset()
>   document that in the new file doc/README.cfi.
> - move "#endif /* CONFIG_CMD_IDE */" to the right place
> - remove LOWBOOT config option for digsy_mtc and digsy_mtc_rev5
>   boards
> - change doc/README.cfi as Stefan Roese suggested
> 
> Signed-off-by: Heiko Schocher <hs at denx.de>
> Signed-off-by: Stefan Roese <sr at denx.de>
> cc: Wolfgang Denk <hs at denx.de>
> cc: Stefan Roese <sr at denx.de>
> cc: Werner Pfister <Pfister_Werner at intercontrol.de>
> cc: Detlev Zundel <dzu at denx.de>

Applied, thanks.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
You're dead, Jim.
	-- McCoy, "Amok Time", stardate 3372.7