[U-Boot] u-boot environment variable parsing

[Hebbar, Gururaja]

Hi wd,

Thanks for the reply. Helped me a lot.

However see below 

On Thu, Jul 21, 2011 at 18:41:30, Wolfgang Denk wrote:
> Dear "Hebbar, Gururaja",
> 
> In message <C82BA3053CFD354AACBD25EFBD2A4EC603F0193C2D at dbde02.ent.ti.com> you wrote:
> > 
> > 
> > The question here is mmc_args re-uses variable bootargs as
> > $(bootargs) & nand_args re-uses it as ${bootargs}. Note the difference 
> > in curly & flower brackets. "run mmc_args" fails for me however 
> > nand_args runs properly.
> 
> Does this not answer your question sufficiently?

The point is mmc_args worked in one place & failed in other. After you reply, I found that the place where it worked was common shell environment & it was failing in Hush shell.

> 
> > My question is
> > 1. Which is correct?
> 
> ${...} is correct.
> 
> > 2. What is the difference between the two?
> 
> ${...} is correct, and $(...) is not correct.
> 
> > I have seen few boards using both methods.
> 
> $(...) was used in very old versions of U-Boot, but this got changed for the sake of compatibility with standard shell syntax.
> 
> Note that the simple cmmand line parser still accepts the obsolete
> $(...) format; the hush shell doesn't.
> 
> Best regards,
> 
> Wolfgang Denk
> 
> -- 
> DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
> HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
> Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de A morsel of genuine history is a  thing  so  rare  as  to  be  always
> valuable.                                          - Thomas Jefferson
> 

Regards, 
Gururaja