[U-Boot] mx28: Saving env vars on MMC

[Marek Vasut]

> On Fri, Nov 25, 2011 at 12:30 PM, Marek Vasut <marek.vasut at gmail.com> wrote:
> > I did the following change and tested u-boot on m28evk. I saved env,
> > restarted board etc.
> > 
> > 1) Env was successfully saved to MMC sector 2 (at offset 1024 bytes from
> > start). 2) Env was successfully loaded from MMC after reset
> > 
> > Basically ... give it a go, Fabio, maybe you just missed something :)
> 
> Thanks for trying it on your board, Marek.
> 
> I applied the same changes here and I still get a corrupted card after
> running "save".
> 
> Will keep investigating.
> 
> Thanks,
> 
> Fabio Estevam

Still writing to block 0 then?

Can you push your current preliminary MX28EVK stuff somewhere so I can check ?

M