[U-Boot] [PATCH 02/12] Davinci: ea20: set GPIOs to hold MII-Phy in reset and set UART0-Switch for console

[Stefano Babic]

On 10/05/2011 02:06 PM, Laurence Withers wrote:
> On Wed, Oct 05, 2011 at 11:43:29AM +0200, Stefano Babic wrote:
>> From: Bastian Ruppert <Bastian.Ruppert at Sewerin.de>
>>
>> Signed-off-by: Bastian Ruppert <Bastian.Ruppert at Sewerin.de>
>> Signed-off-by: Stefano Babic <sbabic at denx.de>
>> CC: dzu at denx.de
>> CC: Sandeep Paulraj <s-paulraj at ti.com>
>> ---
>>  arch/arm/include/asm/arch-davinci/hardware.h |    4 +++
>>  board/davinci/ea20/ea20.c                    |   30 +++++++++++++++++++++++++-
>>  2 files changed, 33 insertions(+), 1 deletions(-)
> 
> There are generic GPIO functions (asm/gpio.h) for DaVinci; you should
> probably use those instead of directly programming the registers.

Right. Then I prepare an additional patch to clean up all direct access
to gpio registers to this files and I add to this patchset.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================