[U-Boot] [PATCH 2/3] OMAP3: overo: Move ethernet CS4 configuration to execute based on board id

[Philip Balister]

By moving the CS4 configuration into the board specific configuration, it
is left free for custom carrier boards. The USRP-E1XX series uses
CS4 to control access to an FPGA, so without this patch the device driver
cannot claim CS4.

Signed-off-by: Philip Balister <philip at opensdr.com>
---
 board/overo/overo.c |    7 +++----
 1 files changed, 3 insertions(+), 4 deletions(-)

diff --git a/board/overo/overo.c b/board/overo/overo.c
index 850dfee..2f9eba6 100644
--- a/board/overo/overo.c
+++ b/board/overo/overo.c
@@ -233,6 +233,9 @@ int misc_init_r(void)
 		printf("Recognized Tobi Duo expansion board (rev %d %s)\n",
 			expansion_config.revision,
 			expansion_config.fab_revision);
+		/* second lan chip */
+		enable_gpmc_cs_config(gpmc_lan_config, &gpmc_cfg->cs[4],
+		    0x2B000000, GPMC_SIZE_16M);
 		break;
 	case GUMSTIX_PALO35:
 		printf("Recognized Palo35 expansion board (rev %d %s)\n",
@@ -310,10 +313,6 @@ static void setup_net_chip(void)
 	enable_gpmc_cs_config(gpmc_lan_config, &gpmc_cfg->cs[5], 0x2C000000,
 			GPMC_SIZE_16M);
 
-	/* second lan chip */
-	enable_gpmc_cs_config(gpmc_lan_config, &gpmc_cfg->cs[4], 0x2B000000,
-			GPMC_SIZE_16M);
-
 	/* Enable off mode for NWE in PADCONF_GPMC_NWE register */
 	writew(readw(&ctrl_base ->gpmc_nwe) | 0x0E00, &ctrl_base->gpmc_nwe);
 	/* Enable off mode for NOE in PADCONF_GPMC_NADV_ALE register */
-- 
1.7.6.4