[U-Boot] [PATCH v2 5/7] da850/omap-l138: Fix NAND flash timings

Prabhakar Lad prabhakar.lad at ti.com
Thu Jun 7 11:55:32 CEST 2012


From: Lad, Prabhakar <prabhakar.lad at ti.com>

Though Commit id a3f88293ddd13facd734769c1664d35ab4ed681f (da850evm:
setup the NAND flash timings) has configured the AEMIF timings, they
are not exactly in sync with the timings used in Linux. Linux is
configuring the timing register as 0x08222204, where as currently it
configured to 0x00100084 in U-Boot. This issue was found out when
support for NAND SPL is added in U-Boot. Without this patch U-Boot
does not come up with SPL.

Signed-off-by: Lad, Prabhakar <prabhakar.lad at ti.com>
Signed-off-by: Rajashekhara, Sudhakar <sudhakar.raj at ti.com>
Signed-off-by: Hadli, Manjunath <manjunath.hadli at ti.com>
---
 board/davinci/da8xxevm/da850evm.c |   10 +++++-----
 1 files changed, 5 insertions(+), 5 deletions(-)

diff --git a/board/davinci/da8xxevm/da850evm.c b/board/davinci/da8xxevm/da850evm.c
index 0d75b84..1c0f75d 100644
--- a/board/davinci/da8xxevm/da850evm.c
+++ b/board/davinci/da8xxevm/da850evm.c
@@ -348,11 +348,11 @@ int board_init(void)
 	 * NAND CS setup - cycle counts based on da850evm NAND timings in the
 	 * Linux kernel @ 25MHz EMIFA
 	 */
-	writel((DAVINCI_ABCR_WSETUP(0) |
-		DAVINCI_ABCR_WSTROBE(1) |
-		DAVINCI_ABCR_WHOLD(0) |
-		DAVINCI_ABCR_RSETUP(0) |
-		DAVINCI_ABCR_RSTROBE(1) |
+	writel((DAVINCI_ABCR_WSETUP(2) |
+		DAVINCI_ABCR_WSTROBE(2) |
+		DAVINCI_ABCR_WHOLD(1) |
+		DAVINCI_ABCR_RSETUP(1) |
+		DAVINCI_ABCR_RSTROBE(4) |
 		DAVINCI_ABCR_RHOLD(0) |
 		DAVINCI_ABCR_TA(1) |
 		DAVINCI_ABCR_ASIZE_8BIT),
-- 
1.7.4.1



More information about the U-Boot mailing list