[U-Boot] Regarding Kernel not starting

[Mark Jackson]

On 08/03/13 09:56, Ramesh K Khokhani wrote:
> Hi Friends,
> 
> I have successfully run u-boot our my custom board but I can't run kernel.
> Problem is that I have saved uImage.bin at NOR location 0x800000 and load into DRAM:0x41000000. Here u-boot can get kernel info and print into UART consol but after loading uncompressed image from 0x41000000 to 0x40020000 u-boot transfer its control to linux kernel and here my hardware goes reset means can't run kernel at 0x40020000.
> 
> Following is the log of consol:
> 
> U-Boot 2011.09 (Jan 23 2013 - 17:16:07)
> 
> CPU:   BTAM MCF5329 (Mask:54 Version:2)
>        CPU CLK 240 MHz BUS CLK 80 MHz
> Board: BTAM 5329
> I2C:   ready
> DRAM:  32 MiB
> Flash: 16 MiB
> In:    serial
> Out:   serial
> Err:   serial
> Net:   Link UP timeout
> FEC0
> Hit any key to stop autoboot:  5  4  3  2  1  0
> ## Booting kernel from Legacy Image at 41000000 ...
>    Image Name:
>    Created:      2013-03-04  12:03:52 UTC
>    Image Type:   M68K Linux Kernel Image (gzip compressed)
>    Data Size:    1549021 Bytes = 1.5 MiB
>    Load Address: 40020000
>    Entry Point:  40020000
>    Verifying Checksum ... OK
>    Uncompressing Kernel Image ... OK

Once you've got this point, you're no longer in the U-Boot environment.

I suggest you repost over on one of the Linux mailing lists.

Regards
Mark J.