[U-Boot] [PATCH v3 3/4] imx: mx6sabresd: Add clear print for pfuze200

[Li Ye-B37916]

Hi Stefano,

On 9/12/2014 6:13 PM, Stefano Babic wrote:
> Hi Ye,
>
> On 11/09/2014 05:13, Ye.Li wrote:
>> Add clear print log to show pfuze200 or pfuze100 found on mx6sabresd.
>>
>> Signed-off-by: Ye.Li <B37916 at freescale.com>
>> ---
>> Changes since v1:
>> - None
>>
>> Changes since v2:
>> - None
>>
>>  board/freescale/mx6sabresd/mx6sabresd.c |    3 ++-
>>  1 files changed, 2 insertions(+), 1 deletions(-)
>>
>> diff --git a/board/freescale/mx6sabresd/mx6sabresd.c b/board/freescale/mx6sabresd/mx6sabresd.c
>> index 5f65f1b..72d6562 100644
>> --- a/board/freescale/mx6sabresd/mx6sabresd.c
>> +++ b/board/freescale/mx6sabresd/mx6sabresd.c
>> @@ -472,7 +472,8 @@ static int pfuze_init(void)
>>  		return ret;
>>  
>>  	pmic_reg_read(p, PFUZE100_DEVICEID, &reg);
>> -	printf("PMIC:  PFUZE100 ID=0x%02x\n", reg);
>> +	printf("PMIC:  PFUZE%s ID=0x%02x\n",
>> +		((reg & 0xf) == 0) ? "100" : "200", reg);
>>  
>>  	/* Increase VGEN3 from 2.5 to 2.8V */
>>  	pmic_reg_read(p, PFUZE100_VGEN3VOL, &reg);
>>
> This is completely unrelated to the series - it can be applied
> independently from the other patches. You do not need to resend this one
> but please send in future patches belonging to the same series if they
> are related to the same issue or to the same set of issues. This
> simplifies review and merging - thanks !
>
> Acked-by: Stefano Babic <sbabic at denx.de>
>
> Best regards,
> Stefano Babic
>

Thanks for your comments. I feel this patch has somewhat relation with others, that in 4/4 the pfuze mode setup needs to consider the pfuze chip type. Of course, this patch can be applied independently.  I will be more careful about the patch set in future.

Best regards,
Ye Li