[U-Boot] [PATCH 0/4] Add support for Cadence QSPI on K2G

[Vignesh R]

Hi,

On 05/09/2016 08:04 PM, Jagan Teki wrote:
> On 13 April 2016 at 16:22, Vignesh R <vigneshr at ti.com> wrote:
>>
>> This series adds support for Cadence QSPI controller present on K2G SoC.
>>
>> The first patch extends AHB address to 32 bit as K2G has 32 bit AHB
>> address. Second patch enable QUAD mode based on DT data instead of
>> relying on config option. And last to patches add DT node and add
>> configs to enable the driver.
>>
>> Depends on [1] to enable SPI driver model support on K2G and [2] to
>> support different bus frequencies for two different SPI controllers
>> present on K2G EVM.
>>
>> [1]https://www.mail-archive.com/u-boot@lists.denx.de/msg209556.html
>> [2]https://patchwork.ozlabs.org/patch/609947/
>>
>> Vignesh R (4):
>>   spi: cadence_qspi_apb: Support 32 bit AHB address
>>   spi: cadence_quadspi: Enable QUAD mode based on DT data
>>   ARM: dts: K2G: Add support for QSPI controller
> 
> Please rebase this?

This series applies cleanly on current u-boot master provided dts
changes from my earlier patch series [3] are picked up. [3] is required
to support SPI DM on K2G. Could you please pick up the dependent series
and then apply this?

[3] https://www.mail-archive.com/u-boot@lists.denx.de/msg211787.html
(Convert davinci_spi to DM patch series)


> 
>>   defconfig: k2g_evm_defconfig: Enable Cadence QSPI controller
> 
> Reviewed-by: Jagan Teki <jteki at openedev.com>
> 

-- 
Regards
Vignesh