[U-Boot] [PATCHv2 1/3] igep00x0: disable CONFIG_DISPLAY_BOARDINFO

[Ladislav Michl]

On Fri, Nov 04, 2016 at 12:42:57PM -0300, Javier Martinez Canillas wrote:
> Hello Ladis,
> 
> On 11/04/2016 08:55 AM, Ladislav Michl wrote:
> > As a single U-Boot binary can now run on various board modifications,
> > drop CONFIG_DISPLAY_BOARDINFO as it prints flash memory information
> > too early to give us chance to easily detect it. Also saves few bytes
> > as a bonus.
> > 
> > Signed-off-by: Ladislav Michl <ladis at linux-mips.org>
> > ---
> 
> I tried to test your patches on latest u-boot master (sha-1 dd93a8e9e688)
> but my IGEPv2 board fails to boot and prints in an infinite loop following:
> 
> "ecc unrecoverable error"

This comes from SPL, right? That would imply you boot from NAND...

> This is not related to your patches though, since I've the same issue
> without your patches applied.
> 
> Did you see this issue? u-boot works with previous v2016.09 release so
> this is a newly introduced regression.

No, otherwise I would fix that. Care to send complete boot log if there is
any?

> Unfortunately I don't have time to dig deeper on this but I may give a
> try next week.

Thank you,
	ladis