[U-Boot] MMC boot / mvebu / clearfog

[Christoph Egger]

Hi!

  MMC boot on the ClearFog (base) still seems to fail (uart boot works
fine apart from uart detection). The SPL seems to finish successfully
and jump to u-boot but there is no further output then. I'm trying to
enable even more `DEBUG` but help is indeed welcome!

Regards

  Christoph

=================================================================
spl_init()

U-Boot SPL 2016.09-dirty (Oct 02 2016 - 22:04:41)
High speed PHY - Version: 2.0
Detected Device ID 6828
board SerDes lanes topology details:
 | Lane #  | Speed |  Type       |
 --------------------------------
 |   0    |  3   |  SATA0	|
 |   1    |  0   |  SGMII1	|
 |   2    |  5   |  PCIe1	|
 |   3    |  5   |  USB3 HOST1	|
 |   4    |  5   |  PCIe2	|
 |   5    |  0   |  SGMII2	|
 --------------------------------
PCIe, Idx 1: detected no link
PCIe, Idx 2: detected no link
High speed PHY - Ended Successfully
DDR3 Training Sequence - Ver TIP-1.29.0
DDR3 Training Sequence - Switching XBAR Window to FastPath Window
DDR3 Training Sequence - Ended Successfully
BOOTROM_REG=0xe7001000 boot_device=0xe
SAR_REG=0xdb00331e boot_device=0x31
>>spl:board_init_r()
BOOTROM_REG=0xe7001000 boot_device=0xe
SAR_REG=0xdb00331e boot_device=0x31
Trying to boot from MMC1
sdhci_transfer_data: Error detected in status(0x408000)!
spl: mmc boot mode: raw
hdr read sector 141, count=1
mkimage signature not found - ih_magic = e1a0000d
read 190 sectors to 800000
Jumping to U-Boot
SPL malloc() used 0x394 bytes (0 KB)
loaded - jumping to U-Boot...image entry point: 0x800000

-- 
9FED 5C6C E206 B70A 5857  70CA 9655 22B9 D49A E731
Debian Developer | Lisp Hacker | CaCert Assurer