[U-Boot] [PATCH 2/4] dts: socfpga: Add trigger-address property to QSPI device

[Marek Vasut]

On 05/19/2017 06:29 PM, Rush, Jason A. wrote:
> On 5/19/2017 1:09 AM , Marek Vasut wrote:
>> On 05/18/2017 08:26 PM, Rush, Jason A. wrote:
>>> Add the 'cdns,trigger-address' property to the cadence QSPI device
>>> node for Altera SoC devices.
>>>
>>> Signed-off-by: Jason A. Rush <jason.rush at gd-ms.com>
>>
>> +CC Dinh, is that address correct ? I think there was some discussion.
> 
> There was some discussion on this before here:
> https://lists.denx.de/pipermail/u-boot/2017-March/282882.html
> 
>> Jason, I'd rather prefer if you sent this as a series (with git
>> send-email) not as a set of separate patches. Also, I'd prefer if you
>> would just sync up the whole block with standard agreed-upon (linux)
>> DT bindings and then ev. tweak the driver.
>>
> 
> I can't use git send-email from this email account, but I can switch to my
> personal gmail account which should work.  I'll CC my other account and
> switch to using that from now on.
> 
> I can try and sync up the DT bindings with Linux, most of the parameters
> should be easy enough to convert.  However, there are two bindings that
> the u-boot driver defines but Linux looks them up from a table or from
> querying the flash part ("page-size" and "block-size"), and one binding
> Linux defines where u-boot calculates ("cdns,read-delay").

I guess you can keep those.

> It would require significant changes to the u-boot driver to adopt these
> 3 bindings, would it be acceptable to align all the other DT bindings, with
> the exception of those 3 bindings?
>  
> --
> Regards,
> Jason Rush
> 


-- 
Best regards,
Marek Vasut