[U-Boot] [PATCH 1/5] fix: env: Fix the SPI flash device setup for DM mode

[kostap at marvell.com]

From: Konstantin Porotchkin <kostap at marvell.com>

For some reason the spi_flash_probe_bus_cs() is called
inside the setup_flash_device() with zero values in place
of configurated SPI flash mode and maximum flash speed.
This code causes HALT error during startup environment
relocation on some platforms - namely Armada-38x-GP board.
Fix the function call by replacing zeros with the appropriate
values - CONFIG_ENV_SPI_MAX_HZ and CONFIG_ENV_SPI_MODE.

Signed-off-by: Konstantin Porotchkin <kostap at marvell.com>
Cc: Igal Liberman <igall at marvell.com>
Cc: Stefan Roese <sr at denx.de>
---
 env/sf.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/env/sf.c b/env/sf.c
index 4945105..2e3c600 100644
--- a/env/sf.c
+++ b/env/sf.c
@@ -58,7 +58,8 @@ static int setup_flash_device(void)
 
 	/* speed and mode will be read from DT */
 	ret = spi_flash_probe_bus_cs(CONFIG_ENV_SPI_BUS, CONFIG_ENV_SPI_CS,
-				     0, 0, &new);
+				     CONFIG_ENV_SPI_MAX_HZ, CONFIG_ENV_SPI_MODE,
+				     &new);
 	if (ret) {
 		set_default_env("spi_flash_probe_bus_cs() failed", 0);
 		return ret;
-- 
2.7.4