[U-Boot] [U-Boot,RESEND,10/10] imx: support i.MX8QM MEK board

[Marcel Ziswiler]

Hi Stefano

On Fri, 2019-04-26 at 09:37 +0000, sbabic at denx.de wrote:
> > Add i.MX8QM MEK board support.
> > Included a basic dts, enabled SPL FIT
> > Boot log as below:
> > U-Boot SPL 2019.01-rc1-00029-gf002213219 (Dec 24 2018 - 10:28:30
> > +0800)
> > Normal Boot
> > Trying to boot from MMC2_2
> > U-Boot 2019.01-rc1-00029-gf002213219 (Dec 24 2018 - 10:28:30 +0800)
> > CPU:   NXP i.MX8QM RevB A53 at 142933 MHz
> > Model: Freescale i.MX8QM MEK
> > Board: iMX8QM MEK
> > Build: SCFW 9330215b
> > Boot:  SD1
> > DRAM:  6 GiB
> > MMC:   FSL_SDHC: 0, FSL_SDHC: 1
> > Loading Environment from MMC... *** Warning - bad CRC, using
> > default environment
> > In:    serial at 5a060000
> > Out:   serial at 5a060000
> > Err:   serial at 5a060000
> > Net:
> > Error: ethernet at 5b040000 address not set.
> > eth-1: ethernet at 5b040000
> > Hit any key to stop autoboot:  0
> > Signed-off-by: Peng Fan <peng.fan at nxp.com>
> 
> Applied to u-boot-imx, master, thanks !

This one introduced a superfluous trailing line continuation in the
Makefile:

https://git.denx.de/?p=u-boot/u-boot-imx.git;a=commitdiff;h=0d331c035a091c1c1af4180b40bd234e3b87e80a#patch1

I will fix this and also make sure stuff is alphabetically sorted again
in my updated Colibri iMX8X introduction patch. OK?

> Best regards,
> Stefano Babic

Cheers

Marcel