[PATCH v1 5/5] arm: xea: dts: Add 'fec-3v3' regulator properties to prevent accidental disablement

[sbabic at denx.de]

> The 'enable-active-high' DTS property configures GPIO so it is active with
> HIGH state (by default it is low).
> The 'regulator-boot-on' property indicates that the regulator was enabled
> in the 'earlier' stage - i.e. bootloader/firmware.
> In the XEA case the 'fec-3v3' was configured (as a "wrapper" on GPIO0_0) in
> very early SPL code, so it shouldn't be modified at latter stages.
> Signed-off-by: Lukasz Majewski <lukma at denx.de>
Applied to u-boot-imx, master, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================