[PATCH 4/4] sunxi: defconfig: R40 boards: enable USB

Andre Przywara andre.przywara at arm.com
Thu Jan 2 00:44:49 CET 2020


Now that the USB PHY on the Allwinner R40 SoC is supported, enable USB
support for the two R40 boards U-Boot supports.
For this we need to add the GPIO pin that powers the USB port(s), also
enable the usual suspects (OHCI/EHCI support).

Signed-off-by: Andre Przywara <andre.przywara at arm.com>
---
 configs/Bananapi_M2_Ultra_defconfig | 4 ++++
 configs/bananapi_m2_berry_defconfig | 4 ++++
 2 files changed, 8 insertions(+)

diff --git a/configs/Bananapi_M2_Ultra_defconfig b/configs/Bananapi_M2_Ultra_defconfig
index 7a30dd7f7f..bbf931329c 100644
--- a/configs/Bananapi_M2_Ultra_defconfig
+++ b/configs/Bananapi_M2_Ultra_defconfig
@@ -19,4 +19,8 @@ CONFIG_SUN8I_EMAC=y
 CONFIG_AXP_DLDO4_VOLT=2500
 CONFIG_AXP_ELDO3_VOLT=1200
 CONFIG_SCSI=y
+CONFIG_USB_EHCI_HCD=y
+CONFIG_USB_OHCI_HCD=y
+CONFIG_USB1_VBUS_PIN="PH23"
+CONFIG_USB2_VBUS_PIN="PH23"
 CONFIG_SYS_USB_EVENT_POLL_VIA_INT_QUEUE=y
diff --git a/configs/bananapi_m2_berry_defconfig b/configs/bananapi_m2_berry_defconfig
index a97be06188..654974e47d 100644
--- a/configs/bananapi_m2_berry_defconfig
+++ b/configs/bananapi_m2_berry_defconfig
@@ -17,3 +17,7 @@ CONFIG_AXP_ELDO3_VOLT=1200
 CONFIG_SCSI=y
 CONFIG_SUN8I_EMAC=y
 CONFIG_RGMII=y
+CONFIG_USB_EHCI_HCD=y
+CONFIG_USB_OHCI_HCD=y
+CONFIG_USB1_VBUS_PIN="PH23"
+CONFIG_SYS_USB_EVENT_POLL_VIA_INT_QUEUE=y
-- 
2.14.5



More information about the U-Boot mailing list