[PATCH 0/6] rockchip: rk3328: sync dts and add ROC-RK3328-CC board
Kurt Miller
kurt at intricatesoftware.com
Fri Mar 27 16:07:35 CET 2020
On Fri, 2020-03-27 at 12:41 +0800, Chen-Yu Tsai wrote:
> From: Chen-Yu Tsai <wens at csie.org>
>
> Hi everyone,
>
> This series adds proper support for Firefly / Libre Computer ROC-RK3328-CC
> single board computer.
>
> The ROC-RK3328-CC from Firefly and Libre Computer Project is a credit
> card size development board based on the Rockchip RK3328 SoC, with:
>
> - 1/2/4 GB DDR4 DRAM
> - eMMC connector for optional module
> - micro SD card slot
> - 1 x USB 3.0 host port
> - 2 x USB 2.0 host port
> - 1 x USB 2.0 OTG port
> - HDMI video output
> - TRRS connector with audio and composite video output
> - gigabit Ethernet
> - consumer IR receiver
> - debug UART pins
>
> Originally I started with Loic's patches, and syncing the device tree
> files from Linux. That didn't get very far, with SPL failing to detect
> the SD card. Examining the schematics and internal state of GRF and
> GPIOs, I realized that the logic for the SD card power enable switch
> is opposite that of what the SD card controller's SDMMC0_PWREN pin
> would use. Instead, directly using the GPIO is required.
>
> Thus this series creates a special target for this board to handle
> muxing this specific pin to GPIO state. The GPIO is left in input mode,
> letting the external pull-down work its magic.
>
> Along the way, there are some clean-ups of existing dts files, moving
> U-boot only features to -u-boot.dtsi files, and then a wholesale sync
> from Linux. Only boards already existing in U-boot are synced. DT
> binding header files are synced separately as there is already one
> patch floating around. The DT sync also includes clean-up changes only
> recently posted, and likely won't make it in for at least a few weeks.
>
> Please have a look, and test if possible. I cc-ed a couple people that
> showed interest in this board on mailing lists recently.
>
Thank you for updating the dts for rk3328. I have Rock64 v2 and v3
boards and have tested your patchset with OpenBSD-current. The v2 board
is working and I have not noticed any regressions. The v3 board prior
to your patchset was not booting and continues to not boot.
U-Boot TPL 2020.04-rc3-00172-gaf827140e5-dirty (Mar 27 2020 - 09:44:24)
LPDDR3, 800MHz
BW=32 Col=11 Bk=8 CS0 Row=15 CS1 Row=15 CS=2 Die BW=16 Size=4096MB
Trying to boot from BOOTROM
Returning to boot ROM...
U-Boot SPL 2020.04-rc3-00172-gaf827140e5-dirty (Mar 27 2020 - 09:44:24 -0400)
Trying to boot from MMC1
Card did not respond to voltage select!
spl: mmc init failed with error: -95
Trying to boot from MMC2
Card did not respond to voltage select!
spl: mmc init failed with error: -95
SPL: failed to boot from all boot devices
### ERROR ### Please RESET the board ###
The Rock64 v3 board issues are unrelated to your patch set, but I
believe it needs a similar approach as ROC-RK3328-CC. Here is some
info previously posted regarding this:
https://marc.info/?t=155751506500001&r=1&w=2
Regards,
-Kurt
> Regards
> ChenYu
>
>
> Chen-Yu Tsai (6):
> rockchip: dts: rk3328-evb: Move vcc5v0-host-xhci-drv to -u-boot.dtsi
> rockchip: dts: rk3328-evb: Move gmac2io related nodes to -u-boot.dtsi
> dt-bindings: clock: rk3328: sync from upstream Linux kernel
> dt-bindings: power: rk3328-power: sync from upstream Linux kernel
> rockchip: dts: rk3328: Sync device tree files from Linux
> rockchip: rk3328: Add support for ROC-RK3328-CC board
>
> arch/arm/dts/Makefile | 1 +
> arch/arm/dts/rk3328-evb-u-boot.dtsi | 39 +
> arch/arm/dts/rk3328-evb.dts | 220 +--
> arch/arm/dts/rk3328-roc-cc-u-boot.dtsi | 17 +
> .../{rk3328-rock64.dts => rk3328-roc-cc.dts} | 135 +-
> arch/arm/dts/rk3328-rock64.dts | 132 +-
> arch/arm/dts/rk3328.dtsi | 1420 +++++++++++------
> arch/arm/mach-rockchip/rk3328/Kconfig | 8 +
> board/firefly/roc-cc-rk3328/Kconfig | 24 +
> board/firefly/roc-cc-rk3328/MAINTAINERS | 7 +
> board/firefly/roc-cc-rk3328/Makefile | 1 +
> board/firefly/roc-cc-rk3328/board.c | 38 +
> configs/roc-cc-rk3328_defconfig | 97 ++
> doc/README.rockchip | 4 +-
> include/dt-bindings/clock/rk3328-cru.h | 212 +--
> include/dt-bindings/power/rk3328-power.h | 19 +
> 16 files changed, 1622 insertions(+), 752 deletions(-)
> create mode 100644 arch/arm/dts/rk3328-roc-cc-u-boot.dtsi
> copy arch/arm/dts/{rk3328-rock64.dts => rk3328-roc-cc.dts} (68%)
> create mode 100644 board/firefly/roc-cc-rk3328/Kconfig
> create mode 100644 board/firefly/roc-cc-rk3328/MAINTAINERS
> create mode 100644 board/firefly/roc-cc-rk3328/Makefile
> create mode 100644 board/firefly/roc-cc-rk3328/board.c
> create mode 100644 configs/roc-cc-rk3328_defconfig
> create mode 100644 include/dt-bindings/power/rk3328-power.h
>
More information about the U-Boot
mailing list