<DIV>Hello to the group, I reviewed the email archive I hope I</DIV>
<DIV>don't repeat anything.</DIV>
<DIV> </DIV>
<DIV>I have just created (mostly copied) a port to the CyberLab</DIV>
<DIV>LN2410SBC board. I have several questions before </DIV>
<DIV>submitting any patch.</DIV>
<DIV> </DIV>
<DIV>What is the status of the NAND code? I have the S3C2410 </DIV>
<DIV>reporting my chip but I have 2040 or 2048 bad blocks. I'll</DIV>
<DIV>work through it, but I don't want to repeat what someone else</DIV>
<DIV>has aleady done.</DIV>
<DIV> </DIV>
<DIV>I have reviewed the thread on the arm920t subdirectory </DIV>
<DIV>structure, I'll follow this for s3c2410x.</DIV>
<DIV> </DIV>
<DIV>Why are there flash drivers in the board directories?</DIV>
<DIV>Is this general enough to be a driver? Should CMD_xxx</DIV>
<DIV>or CONFIG_ xxx defines be used at this level?</DIV>
<DIV> </DIV>
<DIV>ps: There is a problem with the memsetup.S code of the </DIV>
<DIV>smdk2410 the sub r0, r0, r1 should be sub r2, r0, r1 to</DIV>
<DIV>copy the table correctly.</DIV>
<DIV> </DIV>
<DIV>David. </DIV>
<DIV> </DIV>