Hi all,
<br>I have an ocotea board, the denx latest 2.6 and 2.4 kernel and u-boot 1.1.4.
<br>I downloaded everything from Wolfgang's ftp site and followed the instructions by the letter. I tftp into memory (at 100000) and bootm my kernels.
<br>I successfully boot linux 2.6 (2.6.14-rc3) on this board but kernel 2.4 (2.4.25) wont take off.
<br>This is what 2.4 gives me: 
<br>(I added early serial messages for clarity)
<br>
<br>## Booting image at 00100000 ...
<br>&nbsp; &nbsp;Image Name: &nbsp; Linux-2.4.25
<br>&nbsp; &nbsp;Created: &nbsp; &nbsp; &nbsp;2006-02-07 &nbsp; 2:25:05 UTC
<br>&nbsp; &nbsp;Image Type: &nbsp; PowerPC Linux Kernel Image (gzip compressed)
<br>&nbsp; &nbsp;Data Size: &nbsp; &nbsp;628718 Bytes = 614 kB
<br>&nbsp; &nbsp;Load Address: 00000000
<br>&nbsp; &nbsp;Entry Point: &nbsp;00000000
<br>&nbsp; &nbsp;Verifying Checksum ... OK
<br>&nbsp; &nbsp;Uncompressing Kernel Image ... OK
<br>id mach(): done
<br>MMU:enter
<br>MMU:hw init
<br>MMU:mapin
<br>MMU:mapin_ram done
<br>MMU:setio
<br>MMU:exit
<br>setup_arch: enter
<br>setup_arch: bootmem
<br>arch: exit
<br>arch: exit 2
<br>
<br>Anyone has an idea what could be wrong?
<br>
<br>
<br><hr align="left" width="300">
View this message in context: <a href="http://www.nabble.com/u-boot-kernel-parameters-t1077794.html#a2806589">u-boot kernel parameters</a><br>
Sent from the <a href="http://www.nabble.com/Uboot---Users-f553.html">Uboot - Users</a> forum at Nabble.com.