[U-Boot-Users] MPC8266 Abatron config file

[Wolfgang Denk]

In message <200312021130.26182.acurtis at onz.com> you wrote:
> Does anyone have a configuration file which works with u=boot?  I have a file 
> which is good enough to communicate with the board and program the flash. 
> However when I try to run u-boot (type go), the baud rate is not correct. It 
> appears that it is 4X the configured rate. If I remove the Abatron and boot 
> normally, everything works fine.

Well, this is a setting which is definitely hardware  (board)  depen-
dend.  So  if you don't give away any facts about your hardware it is
impossible to help (actually it's probably impossible in  general  as
this might be a custom board).


Best regards,

Wolfgang Denk

-- 
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd at denx.de
Every program has at least one bug and can be shortened by  at  least
one instruction - from which, by induction, one can deduce that every
program can be reduced to one instruction which doesn't work.