[U-Boot-Users] boot linux kernel problem

yu yu at mp-sun1.informatik.uni-mannheim.de
Sat Mar 1 03:17:47 CET 2003


Hello. Everyone.
I use ppcboot and linux on a walnut board for test.
I compile the linux kernel source src-linuxppc_2_4_devel from 
ppckernel.org with the command:
make pImage

then I copy the pImage file to walnut board RAM and boot it.
but the linux kernel hang up after the decompression.
What is the possible reason?
thanks in advance.




PPCBoot 1.2.0 (Mar  1 2003 - 03:04:51)

CPU:   IBM PowerPC 405GP Rev. E at 200 MHz (PLB=100, OPB=50, EBC=50 MHz)
           PCI sync clock at 33 MHz, internal PCI arbiter enabled
           16 kB I-Cache 8 kB D-Cache
Board: ### No HW ID - assuming WALNUT405
I2C:   ready
DRAM:  32 MB
FLASH: 512 kB
In:    serial
Out:   serial
Err:   serial
KGDB:  kgdb ready
ready
BEDBUG:ready
Hit any key to stop autoboot:  0
=> tftpboot 600000 pImage
ENET Speed is 100 Mbps - FULL duplex connection
ARP broadcast 1
TFTP from server 192.168.1.10; our IP address is 192.168.1.20
Filename 'pImage'.
Load address: 0x600000
Loading: #################################################################
         ############################################
done
Bytes transferred = 556097 (87c41 hex)
=> bootm 600000
## Booting image at 00600000 ...
   Image Name:   Linux-2.4.20-pre7
   Created:      2003-03-01   1:06:57 UTC
   Image Type:   PowerPC Linux Kernel Image (gzip compressed)
   Data Size:    556033 Bytes = 543 kB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK


-- 
Maoyuan Yu
FPGA-Processor Group
Dept. of Computer Science V
University of Mannheim
B6,23-29A - 68131 Mannheim - Germany
Phone:+(49)621 181 2631 - Fax:+(49)621 181 3580
mailto:yu at mp-sun1.informatik.uni-mannheim.de
http://cern.ch/myu






More information about the U-Boot mailing list