[U-Boot-Users] Re: IBM 440GX eval name

[Jarrett Redd]

I also have a 440GX eval board from IBM.  I tried the
ocotea config and it boots up just fine.  However, I
get a message about an I2C read error.  Is this
normal?  In addition, I can't seem to bring up the
network.  However, this is my first shot with u-boot
so probably I am doing something stupid.  The docs I
have found so far are pretty good, but relatively
unclear on the network setup.  Is there something I
have to do besides setting some environment variables?
 Or is there some doc that I missed?  Thanks.

-tc

----------------------------------------------------
IBM PowerPC 440 GX Rev. B
Board: IBM 440GX Evaluation Board
        VCO: 1066 MHz
        CPU: 533 MHz
        PLB: 152 MHz
        OPB: 76 MHz
        EPB: 76 MHz
I2C:   ready
DRAM:  I2c read: failed 4
I2c read: failed 4
256 MB
FLASH:  5 MB
PCI:   Bus Dev VenId DevId Class Int
In:    serial
Out:   serial
Err:   serial
KGDB:  kgdb ready
ready
Net:   ppc_440x_eth0
BEDBUG:ready

=> printenv
bootargs=root=/dev/hda1 
bootcmd=bootm ffc00000
baudrate=115200
loads_echo=1
ethaddr=<macaddr>
ipaddr=<ipaddr>
netmask=<netmask>
serverip=<servip>
gatewayip=<gwip>
hostname=<hostname>
netdev=eth0
stdin=serial
stdout=serial
stderr=serial

Environment size: 278/4092 bytes

=> ping <address>
Waiting for PHY auto negotiation to complete.. done
ENET Speed is 100 Mbps - FULL duplex connection
ping failed; host <address> is not alive


__________________________________
Do you Yahoo!?
Yahoo! Small Business $15K Web Design Giveaway 
http://promotions.yahoo.com/design_giveaway/