[U-Boot-Users] U-BOOT for MPC860T customized board

[Wolfgang Denk]

In message <403F04E7.000003.01996 at RAMANAYV> you wrote:
> I have customised board with MPC860T,16MBytes of flash,16MBytes of SDRAM and
> ethernet interface.
> 
> CS0 is using for flash and CS1 is for SDRAM.
> 
> is there any standard board with this configuration.

There are far too many similar boards to mention.

> so,that i can use that board configuration for U-BOOT.

How should we know? Do don't provide any details. MPC860T: running at
which CPU clock frequency? - which bus clock  frequency?  -  with  or
without  32 kHz clock? Flash: which manufacturer? - which type? - how
many chips ? - which bus width? SDRAM: which  manufacturer?  -  which
type?   -   how  many  chips  ?  -  which  bus  width?  SDRAM:  which
manufacturer? - which type? - how many chips ?  -  which  bus  width?
Ethernet: on SCC or FEC? - which PHY? ...

Sorry, but this is something which  requires  intimate  knowledge  of
your hardware, and thus it can be done only by you.

Best regards,

Wolfgang Denk

-- 
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd at denx.de
Due to lack of disk space, this fortune database has been discontinued.