[U-Boot-Users] running u- boot on Virtex II PRO board??

Andrew May acmay at acmay.homeip.net
Wed Jul 7 23:18:53 CEST 2004

On Wed, Jul 07, 2004 at 05:20:01PM +0200, Abdelmajid Bouajila wrote:
> Hello,
> I built my design with EDK (using BSB base system builder)
> I generated my xparameters.h
> I compiled U-boot
> I generate an ace file. ($ xmd genace.tcl -jprog -board ml300 -hw
>      implementation/download.bit -elf u-boot -ace top.ace, I used:
> genace.tcl given by xilinx in a reference design)
> When running u-boot on the ML300 board, I have nothing on Hyperterminal???
> I don't understand where is the problem

Did you check the buadrate/flow control settings?
Do you have any idea if any of the code is actually running as expected?

More information about the U-Boot mailing list