[U-Boot-Users] [PATCH] OMAP1610 cs boot mode

[Wolfgang Denk]

In message <0F6832DAA2EE0B4D9281EDC36F09A8FC0FC3E6 at esebe025.ntc.nokia.com> you wrote:
>
> I included a patch that adds support for CS boot mode recognition on
> OMAP1610 Innovator and H2 boards.
> Currently you have to build U-Boot either for CS0 or CS3 boot mode.
> The patch adds new make targets for binaries that will check the boot
> mode and set flash address accordingly. Also some board specific init
> steps are skipped when booting from RAM.
> The new targets are:
> omap1610h2_cs_autoboot_config
> omap1610inn_cs_autoboot_config

Thanks, added - except for the part which modifies common/env_flash.c

Here, instead  of  simply  initializing  the  relevant  variables  at
compile  time,  you  added code to do this at run time. I don't think
this is a good idea. Please explain why you are doing this, and which
problem you attempt to fix.

Best regards,

Wolfgang Denk

-- 
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd at denx.de
THIS IS A 100% MATTER  PRODUCT:  In  the  Unlikely  Event  That  This
Merchandise  Should  Contact  Antimatter  in Any Form, a Catastrophic
Explosion Will Result.