[U-Boot-Users] MPC5200: Moving SDRAM init out of board scope

Wolfgang Denk wd at denx.de
Mon Jun 28 16:13:34 CEST 2004


In message <0406281605190Q.02269 at pcj86> you wrote:
>
> > I am currently porting U-Boot to a new MPC5200 platform (Total5200). To
> > reduce code duplication I would like to move the Lite5200 / IceCube SDRAM
> > initialization (sdram_start() and initdram()) from board/icecube/icecube.c
> > to cpu/mpc5xxx/sdram.c. So two platforms would use the same code base.
> >
> > Any objections?

If it doesn't break existing board support (IceCube, PM520,  TOP5200)
this is OK with me.

> Sounds good to me. We plan to build our own MPC5200 board based on 
> IceCube/Lite5200 in the near future and we'll run U-Boot on it. So it will be 
> the third board.
> 
> Wolfgang, what's your mind?

Agreed.

Best regards,

Wolfgang Denk

-- 
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd at denx.de
The inappropriate cannot be beautiful.
             - Frank Lloyd Wright _The Future of Architecture_ (1953)




More information about the U-Boot mailing list