[U-Boot-Users] Ethernet On FCC

[Vikrant_Basotra]

Hi all,

We are designing an MPC8260 Board which had an LXT971 Ethernet chip on it.

The ethernet chip is connected to FCC2 port.

1.According to me the Ethernet initialization for FCC is done in the
function "fec_init" in Ether_fcc.c.

  The function "fec_init" is being called in Eth.c/eth_init()

  The function "eth_init" is being called in Net.c/NetLoop().

  The function "NetLoop" is being called in cmd_net.c/netboot_common.

 

  The function "fec_initialize" is being called in eth.c 

  The function "eth_initialize" is being called in board.c

 

I am not able to make out from where fec_init is being called initially?

 

2.Also there is another function "reset_phy" in board.c. Is this the
starting point for Ethernet intialization?

 

Thanks and Regards,

Vikrant.

 

************************************************************************** 
This email (including any attachments) is intended for the sole use of the
intended recipient/s and may contain material that is CONFIDENTIAL AND
PRIVATE COMPANY INFORMATION. Any review or reliance by others or copying or
distribution or forwarding of any or all of the contents in this message is
STRICTLY PROHIBITED. If you are not the intended recipient, please contact
the sender by email and delete all copies; your cooperation in this regard
is appreciated.
**************************************************************************
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.denx.de/pipermail/u-boot/attachments/20041103/cb9ac65a/attachment.htm