[U-Boot-Users] ppc440gx

[Barbier, Renaud (GE Infrastructure)]

I am trying to get U-boot on a custome ppc440gx board (CPU, 64MB RAM and the 2 gigabit port).

I have a problem, I am receiving this exception below. This happen when the EE bit is set in interrupt_init.

kgdb: handle_exception; trap [0xb00]

I am not sure what is the source of this exception. (decrementer should be 0x900)

Before that I was getting exception 0x500(external interrupt) and trace it to the UIC registers(polarity, trigger,...) being cleared (where?).
So I restore their value in interrrupt_init_cpu.  


Note that I have run vxWorks and Linux on this board. I could believe I broke something.



-----Original Message-----
From: u-boot-users-admin at lists.sourceforge.net
[mailto:u-boot-users-admin at lists.sourceforge.net]On Behalf Of
philipv at cam.org
Sent: Thursday, September 02, 2004 3:29 PM
To: u-boot-users at lists.sourceforge.net
Subject: [U-Boot-Users] Booting in IPv6



Is there any support planned or in progress for booting in an IPv6 network?

Philip




-------------------------------------------------------
This SF.Net email is sponsored by BEA Weblogic Workshop
FREE Java Enterprise J2EE developer tools!
Get your free copy of BEA WebLogic Workshop 8.1 today.
http://ads.osdn.com/?ad_id=5047&alloc_id=10808&op=click
_______________________________________________
U-Boot-Users mailing list
U-Boot-Users at lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/u-boot-users