[U-Boot-Users] SM712 + U-Boot
Bora Sahin
bora.sahin at ttnet.net.tr
Wed Apr 6 13:11:09 CEST 2005
Hi,
Pierre> I don't have such information on my board. I own a DK712GX04PC00-00
Pierre> 400029 board.
The problem is here. My eva board number is also DK712GX04PC00 but I think this card is changed! I
sent an e-mail to HyLine but they didnt help much! Only they mentioned some SW1 switch settings and
said "For the SM712 board, SW2 is don't care, so you can put all SW2 to OFF". I deduced "this card
can be changed" from their writings.
Pierre> On the upper right corner of the board, there's two blue dip switch for configuration. The
Pierre> SW1 is used for LCD panel configuration, and SW2 is used for memory configuration.
Yes. I think they changed the card to host either a SM712 or SM722 chip. So they allocate SW2 to
keep the SM722 settings.
Pierre> This hardware configuration is read once at boot time and could be overwritten by software.
Pierre> The SW2:7 switch is connected on the MD6 signal of the SMI712 (on my board) which enable the
Pierre> 32 bits memory data bus. See the SMI712 data book at paragraph 3. If your board hasn't any
Pierre> configuration switch on the MD6 signal, you can try to modify the MCR62 register (address 3c5h,62).
Thanks for the tip. Your point seems reasonable. I examined that part of the doc.(page: 169) The doc
says it's power-on configurable. Also this pins are pulled-up. So their default value is 1 -> 64 bit
internal bus, disable external 32 bit mem etc...
I'll come back after trying it...
--
Bora SAHIN
Best Regards
More information about the U-Boot
mailing list