[U-Boot-Users] Cannot boot from a uImage on the lite5200

[Wolfgang Denk]

In message <528646bc0504190945638591fc at mail.gmail.com> you wrote:
> I'm having problems getting u-boot to boot linux from a uImage on my
> lite5200 eval board.  I can load a zImage into ram (@ 0x200000) and
> use the go command to boot it with no problems.  When I load a uImage

This means that your kernel is probably ok in general...

> I get the bootup debug banners from the linux kernel and then the
> board resets before the "Linux version ..." banner (and then my

...and this means  that  most  preobably  it  is  not  ported  and/or
configured for booting with U-Boot.

> I noticed that the uImage has the load address set to 0x00000000
> instead of the 0x00800000 that the zImage uses.  Is this correct?  I

Yes, this is correct.



Best regards,

Wolfgang Denk

-- 
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
"If that makes any sense to you, you have a big problem."
                                  -- C. Durance, Computer Science 234