[U-Boot-Users] Using "cu" for tranferring files
Swapnil Ashok Narkhede
S3092131 at student.rmit.edu.au
Tue Aug 23 12:34:23 CEST 2005
I did try to use "cu" for tranferring the files.
But i can see the monitor command prompt
and not enter any input.
This problem is related to the flow control,
i reckon, and so i try to figure out how do i set it.
I have used the settings as
mentioned in the DULG manual for setting up "cu".
hardflow is set to false.
but still i cannot input any values.
Is there any other way of setting the hardware
and software flow control to none.
How do i get this working.
Regards,
Swapnil Narkhede
Mob:- 0432025023
Email:- s3092131 at student.rmit.edu.au
School of Computer Science and Information Technology
RMIT University, Melbourne
More information about the U-Boot
mailing list