[U-Boot-Users] My board doesn't boot - ram controller problem?

[Wolfgang Denk]

In message <429F1E26.1010508 at web.de> you wrote:
> 
> I had the following assumptions:
> 
> 1. The MPC875 will try to boot from 0xfff00100 due to my HRCW settings, 
> which cause MSR[IP] to be "1".
> 2. The whole memory is tiled with the first 64K of the flash due to the 
> fact that OR0 is 0x00000ff4 when the board boots, which should mask out 

Did you read the MPC8xx User's Manual about how the  processor  comes
up from reset? Read it again, please.

Best regards,

Wolfgang Denk

-- 
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
There are three things I always forget. Names, faces -  the  third  I
can't remember.                                         - Italo Svevo