[U-Boot-Users] BDI2000 and MPC8260

[Rune Torgersen]

> -----Original Message-----
> From: Pantelis Antoniou
> Sent: Thursday, September 01, 2005 13:44

> > That doesn't sound quite right, but worst case all you need to do
> > is pull RSTCONF to ground and the 82xx will use an internal
> > configuration word to get you going.

> If your boot flash is not written correctly, you'd better
> have a way to pull RSTCONF low. Different BDI settings are
> required however, beware.

Eh.. According to the 8260 Users manual it is excactly opposite...
(8260UM ch 5.4)
RSTCONF should be tied to GND for reading HRCW from EPROM. RSTCONF
should 
be tied to VCC for slave configuration or if you want to use the default

all 0 HRCW.