[U-Boot-Users] [PATCH] ARM: I2C Init function call in lib_arm/board.c
Hebbar
gururajakr at sanyo.co.in
Wed Dec 19 00:34:28 CET 2007
Hi,
we are working on a Customized ARM 926ejs Board. I am trying to port Uboot
for the same board. I found that few patches/changes/updates were required
for arm & ARM926 Specidifc Modules. Below are the Patches for the same
This Patch adds I2C init func call to init sequence for arm boards. This is
present in ppc,blackfin and other processor init sequence.
--- u-boot-1.3.1/lib_arm/board.c 2007-12-06 01:21:19.000000000 -0800
+++ uboot/lib_arm/board.c 2007-12-12 19:57:51.296875000 -0800
@@ -84,6 +84,11 @@ extern void cs8900_get_enetaddr (uchar *
extern void rtl8019_get_enetaddr (uchar * addr);
#endif
+#if defined(CONFIG_HARD_I2C) || \
+ defined(CONFIG_SOFT_I2C)
+#include <i2c.h>
+#endif
+
/*
* Begin and End of memory area for malloc(), and current "brk"
*/
@@ -209,6 +214,16 @@ static void display_flash_config (ulong
}
#endif /* CFG_NO_FLASH */
+#if defined(CONFIG_HARD_I2C) || defined(CONFIG_SOFT_I2C)
+static int init_func_i2c (void)
+{
+ puts ("I2C: ");
+ i2c_init (CFG_I2C_SPEED, CFG_I2C_SLAVE);
+ puts ("ready\n");
+ return (0);
+}
+#endif
+
/*
* Breathe some life into the board...
*
@@ -251,6 +266,9 @@ init_fnc_t *init_sequence[] = {
#if defined(CONFIG_DISPLAY_BOARDINFO)
checkboard, /* display board info */
#endif
+#if defined(CONFIG_HARD_I2C) || defined(CONFIG_SOFT_I2C)
+ init_func_i2c,
+#endif
dram_init, /* configure available RAM banks */
display_dram_config,
NULL,
Signed-off-by: Hebbar
I welcome comments, complaints, suggestions and advices.
Regards
Gururaja
--
View this message in context: http://www.nabble.com/-PATCH--ARM%3A-I2C-Init-function-call-in-lib_arm-board.c-tp14408151p14408151.html
Sent from the Uboot - Users mailing list archive at Nabble.com.
More information about the U-Boot
mailing list