[U-Boot-Users] EABI problem

[Patrice Vilchez]

Hello,

    I am quite new on this mailing list.

    I have tried to build u-boot with the last EABI toolchain from 
codesourcery (arm-2007q1-10 version).
    It seems that in the file "driver/nand/nand_util.c" there is some 64 
bits division which causes a crash during the link process.

bye,
    Patrice.

-----8<

From: Patrice Vilchez <patrice.vilchez at rfo.atmel.com>

Remove 64 bits division into nand driver to compile with an EABI toolchain

Signed-off-by: Patrice Vilchez   <patrice.vilchez at rfo.atmel.com>
---

driver/nand/nand_util.c |   16 ++++++++--------
1 file changed, 8 insertions(+), 8 deletions(-)

diff -Nru u-boot-1.2.0.orig/drivers/nand/nand_util.c 
u-boot-1.2.0.new/drivers/nand/nand_util.c
--- u-boot-1.2.0.orig/drivers/nand/nand_util.c    2007-01-07 
00:13:11.000000000 +0100
+++ u-boot-1.2.0.new/drivers/nand/nand_util.c    2007-07-05 
19:03:03.000000000 +0200
@@ -209,9 +209,9 @@
 
         if (!opts->quiet) {
             int percent = (int)
-                ((unsigned long long)
+                ((unsigned long)
                  (erase.addr+meminfo->erasesize-opts->offset)
-                 * 100 / erase_length);
+                 / erase_length) * 100;
 
             /* output progress message only at whole percent
              * steps to reduce the number of messages printed
@@ -476,9 +476,9 @@
 
         if (!opts->quiet) {
             int percent = (int)
-                ((unsigned long long)
-                 (opts->length-imglen) * 100
-                 / opts->length);
+                ((unsigned long)
+                 (opts->length-imglen)
+                 / opts->length) * 100;
             /* output progress message only at whole percent
              * steps to reduce the number of messages printed
              * on (slow) serial consoles
@@ -652,9 +652,9 @@
 
         if (!opts->quiet) {
             int percent = (int)
-                ((unsigned long long)
-                 (opts->length-imglen) * 100
-                 / opts->length);
+                ((unsigned long)
+                 (opts->length-imglen)
+                 / opts->length) * 100;
             /* output progress message only at whole percent
              * steps to reduce the number of messages printed
              * on (slow) serial consoles