[U-Boot-Users] U-Boot 1.2 - Cannot run hello_world - Coldfire

[Arun Biyani]

I have a target board with a Coldfire CPU. I am unable to run the 
example program
hello_world which comes with the distribution. Transcript of session is 
below. What
am I missing? The cross compile tools were run on Linux (FC 7), 
downloaded from
snapgear.org uClinux directory. I tried this with v1.1.6 also. I'll be 
glad to provide
any additional data. I have just started with U-Boot so please be 
explicit. On the host,
I was running Tera Term and used "send file" from the "File" menu to 
send the srec file.
I ran the program with parameters as well with the same result.

U-Boot 1.2.0 (Jun 13 2007 - 07:36:11)

CPU:   Freescale MCF5272 (Mask:1)
Board: Telasic RLB 2.0
DRAM:  16 MB
FLASH: 32 MB
In:    serial
Out:   serial
Err:   serial
Hit any key to stop autoboot:  0
->
-> ds
Unknown command 'ds' - try 'help'
-> loads
## Ready for S-Record download ...

## First Load Addr = 0x00020000
## Last  Load Addr = 0x000222F7
## Total Size      = 0x000022F8 = 8952 Bytes
## Start Addr      = 0x00020000
-> go 0x00020004
## Starting application at 0x00020004 ...


*** Unexpected exception ***
Vector Number: 4  Format: 04  Fault Status: 0

PC: 00ff94fc    SR: 00002004    SP: 00f6db0c
D0: 00000000    D1: 0000048c    D2: 00000000    D3: 00ff8fac
D4: 000000f3    D5: 00000000    D6: 00000000    D7: 00f7df90
A0: 00fed912    A1: 00ff94fc    A2: 00020004    A3: 00f6ded8
A4: 00000002    A5: 00ff7300    A6: 00f6db8c

*** Please Reset Board! ***