[U-Boot-Users] Reading environment in IXDP425

[Ori Idan]

It seems that saveenv is working.
I checked it using md and verified all variables are saved.
When resetting the board, it hanged up during eth_initialize so it
seems it did read
the flash environment but probably read something wrong.

Does anyone have any idea?

-- 
Ori Idan


On 6/17/07, Ori Idan <ori at helicontech.co.il> wrote:
> This is not the case, I tried changing a variable using setenv,
> verified it was changed, the did saveenv and verified it was saved.
> I then reseted the board and checked the environment
>
> --
> Ori Idan
>
>
> On 6/17/07, Sellathu <selathu at gmail.com> wrote:
> > Ori Idan wrote:
> > > Hello
> > >
> > > I have an IXDP425 working with U-boot.
> > > Saving environment with saveenv works fine (I tried md command to
> > > verify it was saved).
> > > After reset, the board does not read the environment from flash and
> > > keeps using the default environment.
> > >
> > > Does anyone have an idea what might go wrong?
> > >
> > > I have CFG_ENV_IS_IN_FLASH
> > > I do not have CFG_ENV_ADDR_REDUND defined.
> > >
> > >
> > Check whether your environment variable is assigned by any other code.
> > I've faced the same problem with 'ethact' variable, which is set at
> > runtime from net/eth.c
> >
> > --
> > Sellathu
> >
>