[U-Boot-Users] [PATCH] Fix Marvell 88e1145 PHY init code

[Andy Fleming]

Fix a bug in the Marvell 88e1145 PHY init code in the TSEC driver
where the reset was being done after the errata code instead of
before.

Signed-off-by: Haiying Wang <haiying.wang at freescale.com>
Signed-off-by: Andy Fleming <afleming at freescale.com>
---
This one was sent to me a bit ago, but I lost it.  It's going in unless
there are objections.

 drivers/tsec.c |    6 ++++--
 1 files changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/tsec.c b/drivers/tsec.c
index b418773..693328d 100644
--- a/drivers/tsec.c
+++ b/drivers/tsec.c
@@ -1012,14 +1012,16 @@ static struct phy_info phy_info_M88E1145 = {
        "Marvell 88E1145",
        4,
        (struct phy_cmd[]){     /* config */
+                          /* Reset the PHY */
+                          {MIIM_CONTROL, MIIM_CONTROL_RESET, NULL},
+
                           /* Errata E0, E1 */
                           {29, 0x001b, NULL},
                           {30, 0x418f, NULL},
                           {29, 0x0016, NULL},
                           {30, 0xa2da, NULL},

-                          /* Reset and configure the PHY */
-                          {MIIM_CONTROL, MIIM_CONTROL_RESET, NULL},
+                          /* Configure the PHY */
                           {MIIM_GBIT_CONTROL, MIIM_GBIT_CONTROL_INIT, NULL},
                           {MIIM_ANAR, MIIM_ANAR_INIT, NULL},
                           {MIIM_88E1011_PHY_SCR, MIIM_88E1011_PHY_MDI_X_AUTO,
--
1.5.0.2.230.gfbe3d-dirty