[U-Boot-Users] [PATCH] Update board NetStar
Ladislav Michl
ladis at linux-mips.org
Thu May 24 17:21:53 CEST 2007
Signed-off-by: Ladislav Michl <ladis at linux-mips.org>
diff --git a/Makefile b/Makefile
index caa5a0e..9a34e14 100644
--- a/Makefile
+++ b/Makefile
@@ -1954,17 +1954,8 @@ mx1ads_config : unconfig
mx1fs2_config : unconfig
@$(MKCONFIG) $(@:_config=) arm arm920t mx1fs2 NULL imx
-netstar_32_config \
netstar_config: unconfig
- @mkdir -p $(obj)include
- @if [ "$(findstring _32_,$@)" ] ; then \
- echo "... 32MB SDRAM" ; \
- echo "#define PHYS_SDRAM_1_SIZE SZ_32M" >>$(obj)include/config.h ; \
- else \
- echo "... 64MB SDRAM" ; \
- echo "#define PHYS_SDRAM_1_SIZE SZ_64M" >>$(obj)include/config.h ; \
- fi
- @$(MKCONFIG) -a netstar arm arm925t netstar
+ @$(MKCONFIG) $(@:_config=) arm arm925t netstar
omap1510inn_config : unconfig
@$(MKCONFIG) $(@:_config=) arm arm925t omap1510inn
diff --git a/board/netstar/nand.c b/board/netstar/nand.c
index 7852365..eea7455 100644
--- a/board/netstar/nand.c
+++ b/board/netstar/nand.c
@@ -45,23 +45,12 @@ static void netstar_nand_hwcontrol(struct mtd_info *mtd, int cmd)
this->IO_ADDR_W = (void *) IO_ADDR_W;
}
-/*
- * chip R/B detection
- */
-/***
-static int netstar_nand_ready(struct mtd_info *mtd)
-{
- return (*(volatile ushort *)GPIO_DATA_INPUT_REG) & 0x02;
-}
-***/
-
int board_nand_init(struct nand_chip *nand)
{
nand->options = NAND_SAMSUNG_LP_OPTIONS;
nand->eccmode = NAND_ECC_SOFT;
nand->hwcontrol = netstar_nand_hwcontrol;
-/* nand->dev_ready = netstar_nand_ready; */
- nand->chip_delay = 18;
+ nand->chip_delay = 400;
return 0;
}
#endif
diff --git a/include/configs/netstar.h b/include/configs/netstar.h
index 697796a..1a685df 100644
--- a/include/configs/netstar.h
+++ b/include/configs/netstar.h
@@ -48,14 +48,14 @@
#define CONFIG_SETUP_MEMORY_TAGS 1
#define CONFIG_INITRD_TAG 1
-#define CFG_DEVICE_NULLDEV 1 /* enable null device */
#define CONFIG_SILENT_CONSOLE 1 /* enable silent startup */
-
+#define CFG_CONSOLE_INFO_QUIET
/*
* Physical Memory Map
*/
#define CONFIG_NR_DRAM_BANKS 1 /* we have 1 bank of DRAM */
#define PHYS_SDRAM_1 0x10000000 /* SDRAM Bank #1 */
+#define PHYS_SDRAM_1_SIZE (64 * 1024 * 1024)
#define PHYS_FLASH_1 0x00000000 /* Flash Bank #1 */
/*
@@ -63,30 +63,21 @@
*/
#define CFG_FLASH_BASE PHYS_FLASH_1
#define CFG_MAX_FLASH_BANKS 1
-#if (PHYS_SDRAM_1_SIZE == SZ_32M)
-/*#if 1*/
-#define CFG_FLASH_CFI /* Flash is CFI conformant */
-#define CFG_FLASH_CFI_DRIVER /* Use the common driver */
-#define CFG_FLASH_EMPTY_INFO
-#define CFG_MAX_FLASH_SECT 128
-#else
-#define PHYS_FLASH_1_SIZE SZ_1M
+#define PHYS_FLASH_1_SIZE (1 * 1024 * 1024)
#define CFG_MAX_FLASH_SECT 19
#define CFG_FLASH_ERASE_TOUT (5*CFG_HZ) /* in ticks */
#define CFG_FLASH_WRITE_TOUT (5*CFG_HZ)
-#endif
#define CFG_MONITOR_BASE PHYS_FLASH_1
-#define CFG_MONITOR_LEN SZ_256K
+#define CFG_MONITOR_LEN (256 * 1024)
/*
* Environment settings
*/
#define CFG_ENV_IS_IN_FLASH
-#define ENV_IS_SOLITARY
#define CFG_ENV_ADDR 0x4000
-#define CFG_ENV_SIZE SZ_8K
-#define CFG_ENV_SECT_SIZE SZ_8K
+#define CFG_ENV_SIZE (8 * 1024)
+#define CFG_ENV_SECT_SIZE (8 * 1024)
#define CFG_ENV_ADDR_REDUND 0x6000
#define CFG_ENV_SIZE_REDUND CFG_ENV_SIZE
#define CONFIG_ENV_OVERWRITE
@@ -95,14 +86,12 @@
* Size of malloc() pool
*/
#define CFG_GBL_DATA_SIZE 128 /* size in bytes reserved for initial data */
-/* XXX #define CFG_MALLOC_LEN (SZ_64K - CFG_GBL_DATA_SIZE)*/
-#define CFG_MALLOC_LEN SZ_4M
+#define CFG_MALLOC_LEN (4 * 1024 * 1024)
/*
* The stack size is set up in start.S using the settings below
*/
-/* XXX #define CONFIG_STACKSIZE SZ_8K /XXX* regular stack */
-#define CONFIG_STACKSIZE SZ_1M /* regular stack */
+#define CONFIG_STACKSIZE (1 * 1024 * 1024) /* regular stack */
/*
* Hardware drivers
@@ -132,36 +121,25 @@
#define CFG_MAX_NAND_DEVICE 1
#define NAND_MAX_CHIPS 1
#define CFG_NAND_BASE 0x04000000 + (2 << 23)
+#define NAND_ALLOW_ERASE_ALL 1
/*
- * JFFS2 partitions (mtdparts command line support)
+ * partitions (mtdparts command line support)
*/
#define CONFIG_JFFS2_CMDLINE
#define MTDIDS_DEFAULT "nor0=omapflash.0,nand0=omapnand.0"
-#define MTDPARTS_DEFAULT "mtdparts=omapflash.0:8k at 16k(env),8k(r_env),448k at 576k(u-boot);omapnand.0:48M(rootfs0),48M(rootfs1),-(data)"
+#define MTDPARTS_DEFAULT "mtdparts=" \
+ "omapflash.0:8k at 16k(env),8k(r_env),448k at 576k(u-boot);" \
+ "omapnand.0:4M(kernel0),40M(rootfs0),4M(kernel1),40M(rootfs1),-(data)"
-#if 0
-#define CONFIG_COMMANDS (CFG_CMD_BDI | \
- CFG_CMD_BOOTD | \
- CFG_CMD_DHCP | \
- CFG_CMD_ENV | \
- CFG_CMD_FLASH | \
- CFG_CMD_IMI | \
- CFG_CMD_LOADB | \
- CFG_CMD_NET | \
- CFG_CMD_MEMORY | \
- CFG_CMD_PING | \
- CFG_CMD_RUN)
-
-#else
#define CONFIG_COMMANDS (CFG_CMD_BDI | \
CFG_CMD_BOOTD | \
CFG_CMD_DHCP | \
CFG_CMD_ENV | \
CFG_CMD_FLASH | \
+ CFG_CMD_JFFS2 | \
CFG_CMD_NAND | \
CFG_CMD_IMI | \
- CFG_CMD_JFFS2 | \
CFG_CMD_LOADB | \
CFG_CMD_NET | \
CFG_CMD_MEMORY | \
@@ -169,7 +147,6 @@
CFG_CMD_RUN)
#define CONFIG_JFFS2_NAND 1 /* jffs2 on nand support */
-#endif
#define CONFIG_BOOTP_MASK CONFIG_BOOTP_DEFAULT
#define CONFIG_LOOPW
@@ -181,36 +158,31 @@
#define CONFIG_ZERO_BOOTDELAY_CHECK /* allow to break in always */
#undef CONFIG_BOOTARGS /* the boot command will set bootargs*/
#define CFG_AUTOLOAD "n" /* No autoload */
-#define CONFIG_BOOTCOMMAND "run nboot"
+#define CONFIG_BOOTCOMMAND "run fboot"
#define CONFIG_PREBOOT "run setup"
#define CONFIG_EXTRA_ENV_SETTINGS \
+ "autostart=yes\0" \
+ "ospart=0\0" \
"setup=setenv bootargs console=ttyS0,$baudrate " \
"$mtdparts\0" \
- "ospart=0\0" \
"setpart=" \
"if test -n $swapos; then " \
- "if test $ospart -eq 0; then chpart nand0,1; else chpart nand0,0; fi; "\
"setenv swapos; saveenv; " \
- "else " \
- "chpart nand0,$ospart; " \
+ "if test $ospart -eq 0; then setenv ospart 1; else setenv ospart 0; fi; "\
"fi\0" \
"nfsargs=setenv bootargs $bootargs " \
"ip=$ipaddr:$serverip:$gatewayip:$netmask:$hostname::off " \
"nfsroot=$rootpath root=/dev/nfs\0" \
"flashargs=run setpart;setenv bootargs $bootargs " \
- "root=/dev/mtdblock$partition ro " \
+ "root=mtd:rootfs$ospart ro " \
"rootfstype=jffs2\0" \
- "initrdargs=setenv bootargs $bootargs " \
- "ip=$ipaddr:$serverip:$gatewayip:$netmask:$hostname::off\0" \
- "iboot=bootp;run initrdargs;tftp;bootm\0" \
- "fboot=run flashargs;fsload /boot/uImage;bootm\0" \
- "nboot=bootp;run nfsargs;tftp;bootm\0"
+ "fboot=run flashargs;nboot kernel$ospart\0" \
+ "nboot=bootp;run nfsargs;tftp\0"
#if 0 /* feel free to disable for development */
#define CONFIG_AUTOBOOT_KEYED /* Enable password protection */
-#define CONFIG_AUTOBOOT_PROMPT "\nNetStar PBX - boot in %d sec...\n"
-#define CONFIG_AUTOBOOT_DELAY_STR "R" /* 1st "password" */
-#define CONFIG_BOOT_RETRY_TIME 30
+#define CONFIG_AUTOBOOT_PROMPT "\nNetStar PBX - boot in %d secs...\n"
+#define CONFIG_AUTOBOOT_DELAY_STR "." /* 1st "password" */
#endif
/*
@@ -228,7 +200,8 @@
#define CONFIG_AUTO_COMPLETE
#define CFG_MEMTEST_START PHYS_SDRAM_1
-#define CFG_MEMTEST_END PHYS_SDRAM_1 + PHYS_SDRAM_1_SIZE
+#define CFG_MEMTEST_END PHYS_SDRAM_1 + PHYS_SDRAM_1_SIZE - \
+ (CFG_MONITOR_LEN + CFG_MALLOC_LEN + CONFIG_STACKSIZE)
#undef CFG_CLKS_IN_HZ /* everything, incl board info, in Hz */
More information about the U-Boot
mailing list