[U-Boot-Users] [PATCH] M18 flash (Sibley) support (attempt 2)
Vasiliy Leoenenko
vasiliy.leonenko at mail.ru
Wed Apr 23 11:42:21 CEST 2008
Hi, Stefan
> Sorry, but I really forgot about this patch. Could you please resend this
> patch against the current tot, since it doesn't apply cleanly anymore?
I prepared patch for u-boot version 1.3.2. Any comments and suggestions are welcome.
Code(included below) was verified on Mainstone II board with M18 flash chip.
Please don't forget to include it :)
Best regards,
Vasiliy
Signed-off-by: Vasiliy Leonenko <vasiliy.leonenko at mail.ru>
Signed-off-by: Alexey Korolev <akorolex at gmail.com>
====================================================
diff -aupNr a/drivers/mtd/cfi_flash.c b/drivers/mtd/cfi_flash.c
--- a/drivers/mtd/cfi_flash.c 2008-04-21 02:39:38.000000000 +0400
+++ b/drivers/mtd/cfi_flash.c 2008-04-22 16:26:29.000000000 +0400
@@ -77,6 +77,7 @@
#define FLASH_CMD_PROTECT_CLEAR 0xD0
#define FLASH_CMD_CLEAR_STATUS 0x50
#define FLASH_CMD_WRITE_TO_BUFFER 0xE8
+#define FLASH_CMD_WRITE_BUFFER_PROG 0xE9
#define FLASH_CMD_WRITE_BUFFER_CONFIRM 0xD0
#define FLASH_STATUS_DONE 0x80
@@ -136,6 +137,7 @@
#define CFI_CMDSET_MITSU_STANDARD 256
#define CFI_CMDSET_MITSU_EXTENDED 257
#define CFI_CMDSET_SST 258
+#define CFI_CMDSET_INTEL_PROG_REGIONS 512
#ifdef CFG_FLASH_CFI_AMD_RESET /* needed for STM_ID_29W320DB on UC100 */
# undef FLASH_CMD_RESET
@@ -298,7 +300,7 @@ static inline void flash_unmap(flash_inf
/*-----------------------------------------------------------------------
* make a proper sized command based on the port and chip widths
*/
-static void flash_make_cmd (flash_info_t * info, uchar cmd, void *cmdbuf)
+static void flash_make_cmd (flash_info_t * info, ulong cmd, void *cmdbuf)
{
int i;
uchar *cp = (uchar *) cmdbuf;
@@ -308,7 +310,8 @@ static void flash_make_cmd (flash_info_t
#else
for (i = 1; i <= info->portwidth; i++)
#endif
- *cp++ = (i & (info->chipwidth - 1)) ? '\0' : cmd;
+ *cp++ = (i > info->chipwidth) ? '\0' :
+ *((uchar *)&cmd + info->portwidth - i);
}
#ifdef DEBUG
@@ -422,7 +425,7 @@ static ulong flash_read_long (flash_info
* Write a proper sized command to the correct address
*/
static void flash_write_cmd (flash_info_t * info, flash_sect_t sect,
- uint offset, uchar cmd)
+ uint offset, ulong cmd)
{
void *addr;
@@ -605,6 +608,7 @@ static int flash_is_busy (flash_info_t *
int retval;
switch (info->vendor) {
+ case CFI_CMDSET_INTEL_PROG_REGIONS:
case CFI_CMDSET_INTEL_STANDARD:
case CFI_CMDSET_INTEL_EXTENDED:
retval = !flash_isset (info, sect, 0, FLASH_STATUS_DONE);
@@ -664,6 +668,7 @@ static int flash_full_status_check (flas
retcode = flash_status_check (info, sector, tout, prompt);
switch (info->vendor) {
+ case CFI_CMDSET_INTEL_PROG_REGIONS:
case CFI_CMDSET_INTEL_EXTENDED:
case CFI_CMDSET_INTEL_STANDARD:
if ((retcode == ERR_OK)
@@ -792,6 +797,7 @@ static int flash_write_cfiword (flash_in
flag = disable_interrupts ();
switch (info->vendor) {
+ case CFI_CMDSET_INTEL_PROG_REGIONS:
case CFI_CMDSET_INTEL_EXTENDED:
case CFI_CMDSET_INTEL_STANDARD:
flash_write_cmd (info, 0, 0, FLASH_CMD_CLEAR_STATUS);
@@ -846,6 +852,7 @@ static int flash_write_cfibuffer (flash_
int flag = 0;
uint offset = 0;
unsigned int shift;
+ uchar write_cmd;
switch (info->portwidth) {
case FLASH_CFI_8BIT:
@@ -900,10 +907,13 @@ static int flash_write_cfibuffer (flash_
sector = find_sector (info, dest);
switch (info->vendor) {
+ case CFI_CMDSET_INTEL_PROG_REGIONS:
case CFI_CMDSET_INTEL_STANDARD:
case CFI_CMDSET_INTEL_EXTENDED:
+ write_cmd = (info->vendor == CFI_CMDSET_INTEL_PROG_REGIONS) ?
+ FLASH_CMD_WRITE_BUFFER_PROG : FLASH_CMD_WRITE_TO_BUFFER;
flash_write_cmd (info, sector, 0, FLASH_CMD_CLEAR_STATUS);
- flash_write_cmd (info, sector, 0, FLASH_CMD_WRITE_TO_BUFFER);
+ flash_write_cmd (info, sector, 0, write_cmd);
retcode = flash_status_check (info, sector,
info->buffer_write_tout,
"write to buffer");
@@ -911,7 +921,7 @@ static int flash_write_cfibuffer (flash_
/* reduce the number of loops by the width of
* the port */
cnt = len >> shift;
- flash_write_cmd (info, sector, 0, (uchar) cnt - 1);
+ flash_write_cmd (info, sector, 0, cnt - 1);
while (cnt-- > 0) {
switch (info->portwidth) {
case FLASH_CFI_8BIT:
@@ -1038,6 +1048,7 @@ int flash_erase (flash_info_t * info, in
for (sect = s_first; sect <= s_last; sect++) {
if (info->protect[sect] == 0) { /* not protected */
switch (info->vendor) {
+ case CFI_CMDSET_INTEL_PROG_REGIONS:
case CFI_CMDSET_INTEL_STANDARD:
case CFI_CMDSET_INTEL_EXTENDED:
flash_write_cmd (info, sect, 0,
@@ -1106,6 +1117,9 @@ void flash_print_info (flash_info_t * in
info->size >> 20, info->sector_count);
printf (" ");
switch (info->vendor) {
+ case CFI_CMDSET_INTEL_PROG_REGIONS:
+ printf ("Intel Prog Regions");
+ break;
case CFI_CMDSET_INTEL_STANDARD:
printf ("Intel Standard");
break;
@@ -1496,6 +1510,7 @@ static void flash_read_jedec_ids (flash_
info->device_id2 = 0;
switch (info->vendor) {
+ case CFI_CMDSET_INTEL_PROG_REGIONS:
case CFI_CMDSET_INTEL_STANDARD:
case CFI_CMDSET_INTEL_EXTENDED:
cmdset_intel_read_jedec_ids(info);
@@ -1550,6 +1565,7 @@ static int flash_detect_legacy(ulong bas
}
switch(info->vendor) {
+ case CFI_CMDSET_INTEL_PROG_REGIONS:
case CFI_CMDSET_INTEL_STANDARD:
case CFI_CMDSET_INTEL_EXTENDED:
info->cmd_reset = FLASH_CMD_RESET;
@@ -1745,6 +1761,7 @@ ulong flash_get_size (ulong base, int ba
#endif
switch (info->vendor) {
+ case CFI_CMDSET_INTEL_PROG_REGIONS:
case CFI_CMDSET_INTEL_STANDARD:
case CFI_CMDSET_INTEL_EXTENDED:
cmdset_intel_init(info, &qry);
@@ -1822,6 +1839,7 @@ ulong flash_get_size (ulong base, int ba
* supported devices (intel...)
*/
switch (info->vendor) {
+ case CFI_CMDSET_INTEL_PROG_REGIONS:
case CFI_CMDSET_INTEL_EXTENDED:
case CFI_CMDSET_INTEL_STANDARD:
info->protect[sect_cnt] =
More information about the U-Boot
mailing list