No subject
Tue Aug 19 22:18:26 CEST 2008
#define CFG_MALLOC_LEN=09=09(CFG_ENV_SIZE + 10240*1024)
Size of uncompressed:
romfs image: 4965376 bytes,
kernel image: 1044480 bytes.
But the problem disappears when I remove "bootm" from autoscript.
And run:
"bootm 5100000 5400000"
by hand in console after downloading images by the script.
The kernel boots and mounts romfs.
Below I put autoscript and log of deflating images.
Best Regards,
Maciej Witaszek
-------------------- autoscript --------------------------
echo =3D=3D=3D U-boot sets =3D=3D=3D
setenv kernel_img 5100000
setenv romfs_img 5400000
echo =3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D Load uClinux kernel image =3D=
=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D
tftpboot $(kernel_img) uClinux
echo =3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D Load ROMfs image =3D=3D=3D=3D=
=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D
tftpboot $(romfs_img) uClinux_romfs
iminfo $(kernel_img)
iminfo $(romfs_img)
bootm $(kernel_img) $(romfs_img)
--------------------------------------------------------------
--------------- u-boot downloading images ---------------
U-Boot 1.1.2 (Aug 29 2005 - 20:18:29)
CPU: Nios-32 Rev. 3.3 (0x3038)
Reg file size: 256 LO_LIMIT/HI_LIMIT: 1/14
Board: Altera Nios 20K200E Development Kit
In: serial
Out: serial
Err: serial
Hit any key to stop autoboot: 0
eth_init
eth_reset
CS8900 Ethernet chip found!
BOOTP broadcast 1
DHCPHandler: got packet: (src=3D67, dst=3D68, len=3D300) state: 3
Filtering pkt =3D 0
DHCPHandler: got DHCP packet: (src=3D67, dst=3D68, len=3D300) state: 3
DHCP: state=3DSELECTING bp_file: ""
TRANSITIONING TO REQUESTING STATE
Bootfile:
DhcpSendRequestPkt: Sending DHCPREQUEST
Transmitting DHCPREQUEST packet: len =3D 343
DHCPHandler: got packet: (src=3D67, dst=3D68, len=3D300) state: 4
Filtering pkt =3D 0
DHCPHandler: got DHCP packet: (src=3D67, dst=3D68, len=3D300) state: 4
DHCP State: REQUESTING
DHCP_ACK
Bootfile:
DHCP client bound to address 10.0.0.99
*** Warning: no boot file name; using '6300000A.img'
TFTP from server 10.0.0.5; our IP address is 10.0.0.99
Filename '6300000A.img'.
Load address: 0x40000
Loading: #
done
Bytes transferred =3D 405 (195 hex)
## Executing script at 00040000
** Script length: 333
** exec: "echo =3D=3D=3D U-boot sets =3D=3D=3D"
=3D=3D=3D U-boot sets =3D=3D=3D
** exec: "setenv kernel_img 5100000"
** exec: "setenv romfs_img 5400000"
** exec: "echo =3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D Load uClinux kernel =
image =3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D"
=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D Load uClinux kernel image =3D=3D=3D=
=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D
** exec: "tftpboot $(kernel_img) uClinux"
eth_init
eth_reset
CS8900 Ethernet chip found!
Interrupt vector 17: handler 0x3f81920 replacing 0x3f81920
TFTP from server 10.0.0.5; our IP address is 10.0.0.99
Filename 'uClinux'.
Load address: 0x5100000
Loading: #################################################################
##################
done
Bytes transferred =3D 423246 (6754e hex)
** exec: "echo =3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D Load ROMfs image =3D=
=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D"
=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D Load ROMfs image =3D=3D=3D=3D=3D=3D=
=3D=3D=3D=3D=3D=3D=3D=3D=3D
** exec: "tftpboot $(romfs_img) uClinux_romfs"
eth_init
eth_reset
CS8900 Ethernet chip found!
Interrupt vector 17: handler 0x3f81920 replacing 0x3f81920
TFTP from server 10.0.0.5; our IP address is 10.0.0.99
Filename 'uClinux_romfs'.
Load address: 0x5400000
Loading: #################################################################
#################################################################
#################################################################
#################################################################
#################################################################
done
Bytes transferred =3D 1662981 (196005 hex)
** exec: "iminfo $(kernel_img)"
## Checking Image at 05100000 ...
Image Name: uCLinux Kernel Image for NIOS32
Image Type: Unknown Architecture Linux Kernel Image (gzip compressed)
Data Size: 423182 Bytes =3D 413.3 kB
Load Address: 04000000
Entry Point: 04000000
Verifying Checksum ... OK
** exec: "iminfo $(romfs_img)"
## Checking Image at 05400000 ...
Image Name: uClinux ROM disk
Image Type: Unknown Architecture Linux RAMDisk Image (gzip compressed)
Data Size: 1662917 Bytes =3D 1.6 MB
Load Address: 06000000
Entry Point: 06000000
Verifying Checksum ... OK
** exec: "bootm $(kernel_img) $(romfs_img)"
Boot reached stage 1
## Booting image at 05100000 ...
Boot reached stage 2
Boot reached stage 3
Image Name: uCLinux Kernel Image for NIOS32
Image Type: Unknown Architecture Linux Kernel Image (gzip compressed)
Data Size: 423182 Bytes =3D 413.3 kB
Load Address: 04000000
Entry Point: 04000000
Verifying Checksum ... OK
Boot reached stage 4
Boot reached stage 5
Boot reached stage 6
Uncompressing Kernel Image ... Error: inflate() returned -4
GUNZIP ERROR - must RESET board to recover
Boot reached stage -6
####### REBOOT is needed #######
Press reset button on your board
FIXME - on production board do sth better
Unhandled interrupt: 0x0
OK
Boot reached stage 7
Boot reached stage 8
Boot reached stage 9
## Loading Ramdisk Image at 05400000 ...
Boot reached stage 10
Image Name: uClinux ROM disk
Image Type: Unknown Architecture Linux RAMDisk Image (gzip compressed)
Data Size: 1662917 Bytes =3D 1.6 MB
Load Address: 06000000
Entry Point: 06000000
Verifying Checksum ... OK
Boot reached stage 11
Uncompressing ROM image ...Error: inflateInit2() returned -4
GUNZIP ERROR - must RESET board to recover
Boot reached stage -6
####### REBOOT is needed #######
Press reset button on your board
FIXME - on production board do sth better
Unhandled interrupt: 0x0
OK
Boot reached stage 15
Starting kernel at 0x04000000...
More information about the U-Boot
mailing list