[U-Boot] [PATCH 5/6] Add SGMII support for the 8544 DS

[Andy Fleming]

The 8544 DS has an optional SGMII Riser card, which uses different PHY
addresses.  Check if we are in SGMII mode, and invoke the SGMII Riser
setup code if so.

Signed-off-by: Andy Fleming <afleming at freescale.com>
---
 board/freescale/mpc8544ds/mpc8544ds.c |   39 +++++++++++++++++++++++++++++++++
 1 files changed, 39 insertions(+), 0 deletions(-)

diff --git a/board/freescale/mpc8544ds/mpc8544ds.c b/board/freescale/mpc8544ds/mpc8544ds.c
index 4e976b7..1e29773 100644
--- a/board/freescale/mpc8544ds/mpc8544ds.c
+++ b/board/freescale/mpc8544ds/mpc8544ds.c
@@ -32,8 +32,10 @@
 #include <miiphy.h>
 #include <libfdt.h>
 #include <fdt_support.h>
+#include <tsec.h>
 
 #include "../common/pixis.h"
+#include "../common/sgmii_riser.h"
 
 #if defined(CONFIG_DDR_ECC) && !defined(CONFIG_ECC_INIT_VIA_DDRCONTROLLER)
 extern void ddr_enable_ecc(unsigned int dram_size);
@@ -463,6 +465,43 @@ get_board_sys_clk(ulong dummy)
 	return val;
 }
 
+#ifdef CONFIG_TSEC_ENET
+int board_eth_init(bd_t *bis)
+{
+	struct tsec_info_struct tsec_info[2];
+	volatile ccsr_gur_t *gur = (void *)(CFG_MPC85xx_GUTS_ADDR);
+	uint io_sel = (gur->pordevsr & MPC85xx_PORDEVSR_IO_SEL) >> 19;
+	int num = 0;
+
+#ifdef CONFIG_TSEC1
+	SET_STD_TSEC_INFO(tsec_info[num], 1);
+	if (!(gur->pordevsr & MPC85xx_PORDEVSR_SGMII1_DIS))
+		tsec_info[num].flags |= TSEC_SGMII;
+	num++;
+#endif
+#ifdef CONFIG_TSEC3
+	SET_STD_TSEC_INFO(tsec_info[num], 3);
+	if (!(gur->pordevsr & MPC85xx_PORDEVSR_SGMII3_DIS))
+		tsec_info[num].flags |= TSEC_SGMII;
+	num++;
+#endif
+
+	if (!num) {
+		printf("No TSECs initialized\n");
+
+		return 0;
+	}
+
+	if (io_sel & 1)
+		fsl_sgmii_riser_init(tsec_info, num);
+
+
+	tsec_eth_init(bis, tsec_info, num);
+
+	return 0;
+}
+#endif
+
 #if defined(CONFIG_OF_BOARD_SETUP)
 
 void
-- 
1.5.4.GIT