[U-Boot-Users] Quick booting

[conn intel]

Dear Friends,

I am using u-boot and it is first loading into the ram from flash and then
starts booting. The problem is its taking a lot of time in loading the image
from flash to ram and then starts booting from it. Following is the output
for printenv variables. I am new to u-boot and thus not much aware of it. On
other board there is redboot installed and it loads kernel in just flash and
starts booting the kernel.

Kindly let me know if you need any information.

Thank you,
Ankur.

# printenv
bootargs=root=/dev/mtdblock2 rw init=/linuxrc console=ttyS0,115200 mem=32M
rootfstype=jffs2
bootcmd=nand read.jffs2 0x30007FC0 0x80000 0x300000;bootm 0x30007FC0
bootdelay=5
baudrate=115200
ipaddr=10.0.1.8
serverip=10.0.1.2
netmask=255.255.255.0
partition=nand0,2
stdin=serial
stdout=serial
stderr=serial
Environment size: 304/2044 bytes



Snapshot of OUTPUT On BOARD:

NAND read: device 0 offset 0x80000, size 0x300000

Reading data from 0x37f800 -- 100% complete.
 3145728 bytes read: OK
## Booting image at 30007fc0 ...
   Image Name:   Linux-2.6.22.2
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    1382536 Bytes =  1.3 MB
   Load Address: 30008000
   Entry Point:  30008000
   Verifying Checksum ... OK
OK

Starting kernel ...
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.denx.de/pipermail/u-boot/attachments/20080226/5ddc4938/attachment.htm