[U-Boot-Users] [PATCH] PATCH: load ixp42x NPE firmware from separate flash block, remove dead code

[Jean-Christophe PLAGNIOL-VILLARD]

On 23:05 Thu 10 Jan     , Michael Schwingen wrote:
> On Wed, Jan 09, 2008 at 01:30:11PM +0100, Jean-Christophe PLAGNIOL-VILLARD wrote:
> > From: Michael Schwingen <michael at schwingen.org>
> > 
> > Hi,
<snip>
> -	IxNpeMicrocode.o \
>  	IxNpeMh.o \
>  	IxNpeMhConfig.o \
>  	IxNpeMhReceive.o \
> @@ -80,6 +79,9 @@ COBJS := npe.o \
>  	IxNpeMhSolicitedCbMgr.o \
>  	IxNpeMhUnsolicitedCbMgr.o
>  
> +ifndef CONFIG_IXP4XX_NPE_EXT_UCODE_BASE
> +COBJS += IxNpeMicrocode.o
> +endif
>  
>  SRCS	:= $(START:.o=.S) $(SOBJS:.o=.S) $(COBJS:.o=.c)
>  OBJS	:= $(addprefix $(obj),$(SOBJS) $(COBJS))
> 
> 
I will add this to the PATCH: load ixp42x NPE firmware from separate
flash block, remove dead code 
too
Best Regards,
J.
> 
> Having the NPE microcode in a seperate flash sector works well with both
> u-boot and with the OpenWRT patches, which expect the microcode in a
> separate MTD partition, so the code is in flash only once, and it should be
> GPL compliant.
> 
> cu
> Michael
> 
> -------------------------------------------------------------------------
> Check out the new SourceForge.net Marketplace.
> It's the best place to buy or sell services for
> just about anything Open Source.
> http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace
> _______________________________________________
> U-Boot-Users mailing list
> U-Boot-Users at lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/u-boot-users