[U-Boot-Users] [PATCH] at91: Fix to enable using Teridian MII phy (78Q21x3) with at91sam9260

[Anatolij Gustschin]

On the at91sam9260ep development board there is an EEPROM
connected to the TWI interface (PA23, PA24 Peripheral A
multiplexing), so we cannot use these pins as ETX2, ETX3.
This patch configures PA10, PA11 pins for ETX2, ETX3
instead of PA23, PA24 pins.

Signed-off-by: Anatolij Gustschin <agust at denx.de>
---

Hi Manuel,

Wolfgang Denk asked you in another email for a proper patch to fix
this issue so that this could be reviewed on the list and applied by
AT91 custodian. Now I created this patch and a patch description,
but I'm not familiar with at91sam9260 and also do not have an
at91sam9260ep board and cannot test it.

Could you please test this patch and probably fix the patch
description. I composed this description from info in your mails,
but I'm not sure if it is really correct. Also add your "Signed-off-by"
line.

 board/atmel/at91sam9260ek/at91sam9260ek.c |    9 +++++++++
 1 files changed, 9 insertions(+), 0 deletions(-)

diff --git a/board/atmel/at91sam9260ek/at91sam9260ek.c b/board/atmel/at91sam9260ek/at91sam9260ek.c
index 836a0c4..06d8512 100644
--- a/board/atmel/at91sam9260ek/at91sam9260ek.c
+++ b/board/atmel/at91sam9260ek/at91sam9260ek.c
@@ -188,8 +188,17 @@ static void at91sam9260ek_macb_hw_init(void)
 	at91_set_B_periph(AT91_PIN_PA25, 0);	/* ERX2 */
 	at91_set_B_periph(AT91_PIN_PA26, 0);	/* ERX3 */
 	at91_set_B_periph(AT91_PIN_PA27, 0);	/* ERXCK */
+#if defined(CONFIG_AT91SAM9260EK)
+	/*
+	 * use PA10, PA11 for ETX2, ETX3.
+	 * PA23 and PA24 are for TWI EEPROM
+	 */
+	at91_set_B_periph(AT91_PIN_PA10, 0);	/* ETX2 */
+	at91_set_B_periph(AT91_PIN_PA11, 0);	/* ETX3 */
+#else
 	at91_set_B_periph(AT91_PIN_PA23, 0);	/* ETX2 */
 	at91_set_B_periph(AT91_PIN_PA24, 0);	/* ETX3 */
+#endif
 	at91_set_B_periph(AT91_PIN_PA22, 0);	/* ETXER */
 #endif
 
-- 
Best regards,
Anatolij

DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de